eFlow104NB

Power Supply Charger, Single Output, 24VDC @ 10A, Aux Output, FAI, LinQ2 Ready, 115VAC, Board

Altronix eFlow104NB UL Listed Sub-Assembly power supply/charger converts a 120VAC, 60Hz input into a single 24VDC output. It also offers a suite of features that includes fire alarm disconnect, overvoltage protection, and low power disconnect which prevents deep discharge of stand-by batteries.

Specifications

  • Input
    • Voltage: 120VAC 60Hz, 4.5A max.
    • Input Fuse: 6.3A/250V
    • Removable AC input terminal block to facilitate installation and wiring.
  • Output
    • 24VDC output.
    • 10A continuous supply current.
    • Aux. power-limited output rated @ 1A (unswitched).
    • Over Voltage Protection.
    • Filtered and electronically regulated outputs.
  • Battery Charging
    • Built-in charger for sealed lead acid or gel type batteries.
    • Automatic switch over to stand-by battery when AC fails.
    • Transfer to stand-by battery power is instantaneous with no interruption.
    • (Batteries are sold separately).
  • Fire Alarm Disconnect
    • Supervised Fire Alarm disconnect (latching or non latching) 10K EOL resistor. Operates on a normally open (NO) or normally closed (NC) trigger.
  • Supervision
    • AC fail supervision (form "C" contacts).
    • Notification trigger is selectable for 30 seconds (factory set) or 2 hours.
    • Battery fail & presence supervision (form "C" contacts).
    • Low power shutdown. Shuts down DC output terminals if battery voltage drops below 80% of nominal. Prevents deep battery discharge.
  • Electrical
      • Temperature:
        • Operating: 0° C to 49° C (32° F to 120° F).
        • Storage: - 20° C to 70° C ( - 4° F to 158° F).
    • Relative Humidity: 85% +/- 5%.
    • BTU/Hr. (approx.): 123 BTU/Hr.
    • System AC input VA requirement: 540VA.
  • Visual Indicators
    • Green AC Power LED indicates 120VAC present.
    • AC input and DC output LED indicators.
  • Additional Features
    • Short circuit and overload protection.

Agency Listings

UL Listed For:
Access Control System Units (UL294)
Power Supplies for use with Burglar Alarm Systems (UL603)
Power Supplies for Fire Protective Signaling Systems (UL1481)
cUL Listed For:
CSA Standard C22.2 No.205-M1983, Signal Equipment
CAN/ULC - s319-05, Electronic Access Control Systems.
ULC-S318-96 - Power Supplies for Burglar Alarm Systems. Also suitable for Access Control.

Accessories

Name Description
LINQ2 Network Communication Module, Control, Monitor and Report Power Supply Diagnostics, Compatible with eFlow Series and MaximalF Power Supply/Chargers

Dimensions & Weight

Dimensions (approximate):
  • 4.56"W x 8.25"L x 1.5"H (115.8 mm W x 209.5 mm L x 38.1 mm H).
Weights (approximate):
  • Product Weigtht: 1.1 Lbs. (0.5 kg).
  • Shipping Weigtht: 1.25 Lbs. (0.57 kg).